K2 SILICONE BLACK 300g - silicone for sealing engine parts during installation

High quality silicone safe for lambda probes and on-board computers. Meets the requirements of car manufacturers (O.E.M. - Original Equipment Manufacturer). It replaces traditional cork, paper, felt, asbestos and rubber seals. Thanks to the SENSOR SAFE formula, it does not damage lambda probes in modern cars with electronic fuel injection.

Resistant to oils, lubricants, coolants, etc. Can be used in all types and brands of automobiles to seal thermostat compartment lids, oil pans, water pump covers, cooling joint terminals, and more. Resistant to temperatures up to 350 ° C.

Instructions for use:
• 1. The surface must be dry, free from dust, dirt and grease.
• 2. Remove the old, loose seal.
• 3. Apply a small amount of silicone (any excess can be removed with a knife soaked in soapy water).
4. The silicone starts to dry after 5 minutes and is resistant to touch after 1 hour, complete drying occurs after 24 hours. 5. Excess dried silicone can be removed with a razor blade.

Warning: The tube must be properly closed after each use.