Spray Gun Tank 100Ml 0.8Mm

The spray gun is used for painting work. Compressed air is essential for proper gun operation. The paint from the gun magazine and the compressed air supplied to the gun form a mixture of paint and air particles at the exit of the gun nozzle.

INSTRUCTIONS FOR USE

Use a wrench to tighten the nozzle. Check the tightness and tightness of the connections of the compressed air supply system. Blow out the air supply hose before connecting to the system. Before using the gun, make sure that it has been properly cleaned and maintained. Make sure that the container with the coating material is connected so that it is properly sealed.

Adjustable spray jet width

The width and shape of the spray jet can be changed by turning air nozzles. The shape of the stream can be continuously adjusted from flat to round according to your needs. The amount of coating material supplied to the air stream is adjusted by the control knob for the amount of coating material. On the other hand, the intensity of the mixture of coating material and air is adjusted by means of the spray control knob. It is recommended to adjust the flow of the mixture so that the smallest possible particles of coating material are obtained, which will ensure a better distribution of the coating material on the surface.

Working with the gun

When use of the pistol, the distance between the exit of the pistol and the surface to be covered must be between 10 and 15 cm. Try to guide the gun exit perpendicular to the surface you want to paint. Avoid arcuate movements that would cause uneven distribution of the coating material. It is recommended to apply several thin layers instead of one thick one.

Adjusting the air flow

Depending on the type of coating material, the amount of compressed air should be selected by adjusting the control knob. air pressure.

Replacing the nozzle

Be sure to replace the entire set of nozzles. The kit includes a coating nozzle, a needle and an air nozzle.

Needle pack

Check the needle cover for leaks during operation. If significant wear occurs, the seal should be replaced with a seal removal wrench during the regular inspection of the gun.

Cleaning and Maintenance

Disconnect when finished. spray the gun from the compressed air system and empty the tool tank of the remaining coating material. Thoroughly clean the tank of residual paint. Thoroughly clean the entire transport path of the coating material. Inaccurate cleaning will reduce the flux flow of the coating material. Clean the air nozzle with a brush soaked in solvent. Never immerse the entire gun in solvent. Never clean clogged openings with hard objects, as even slight internal damage can adversely affect the spray pattern. After washing the gun, apply a small amount of grease to the moving parts of the seal. Tighten the nozzle of the coating material to prevent leakage and keep the needle moving smoothly.